Warning: preg_replace(): Compilation failed: invalid range in character class at offset 4 in /home/protonee/public_html/blog/wp-content/plugins/crayon-syntax-highlighter/crayon_langs.class.php on line 340
Gadgets3d | Protoneer.co.nz

Tag Archives: Gadgets3d

Configure Marlin Firmware with Ramps 1.4 and GADGETS3D Shield with Panel (LCD and SD)

2013/02/18 9:01 pm / Leave a Comment /

To run the Marlin Firmware on the following setup you need to configure it as below: Arduino Mega 2560 Ramps 1.4 3d Printer Electronics Gadgets3D Shield with Panel (LCD and SD card reader) Configuration.H #define MOTHERBOARD 34  // Sets the Motherboard as Ramps 1.3/1.4 with two extruders #define TEMP_SENSOR_0 1   // This defines the … Read More →

Posted in: 3d Printing, CNC, Shields / Tagged: , ,