To run the Marlin Firmware on the following setup you need to configure it as below:
- Arduino Mega 2560
- Ramps 1.4 3d Printer Electronics
- Gadgets3D Shield with Panel (LCD and SD card reader)
- #define MOTHERBOARD 34 // Sets the Motherboard as Ramps 1.3/1.4 with two extruders
- #define TEMP_SENSOR_0 1 // This defines the first temperature sensor as a 100k thermistor.
- #define G3D_PANEL // Un-comment this line to enable the Gadgets3d LCD and SD panel.